IntegaDesign › SuCri® Knowledge Base › 📄 4.5 Calculation of wafer-type screws (WF)

4.5.9. Hide all centerlines on the drawing (SuCri4HideAllCenterLine)

4.5.9. Hide all center lines on the drawing (SuCri4HideAllCenterLine)

Copyright © 2025 by IntegaDesign GmbH. All Rights Reserved.
  • 4.5.1. Attaching (SuCri4AttachSupport)
  • 4.5.2. Attaching with reference (SuCri4AttachSupportWithRef)
  • 4.5.3. Update Scale of All Views (SuCri4ChangeAllViewScale)
  • 4.5.4. Change the scale of the selected view (SuCri4ChangeViewScale)
  • 4.5.5. Check whether drawing was created with SuCri (SuCri4CheckSuCriDrawing)
  • 4.5.6. Detach all Xrefs (SuCri4DetachAllXref)
  • 4.5.7. Detaching (SuCri4DetachSupport)
  • 4.5.8. Detach Xref (SuCri4DetachXref)
  • 4.5.10. Load Settings (SuCri4LoadSetting)
  • 4.5.11. Label view with Ortho Annotations (SuCri4PlantOrthoAnnotate)
  • 4.5.12. Create single drawing (SuCri4PlantOrthoCreateMultiple)
  • 4.5.13. Create multiple drawings (SuCri4PlantOrthoCreateMultipleSU)
  • 4.5.14. Labeling the View with Custom Annotations (SuCri4PlantOrthoCustomAnnotate)
  • 4.5.15. Dimension view (SuCri4PlantOrthoDimension)
  • 4.5.16. Defining Drawing Areas (SuCri4PlantOrthoDrawArea)
  • 4.5.17. Refresh view (SuCri4PlantOrthoDrawArea)
  • 4.5.18. Update all views (SuCri4PlantOrthoUpdateAllView)
  • 4.5.19. Defining the Front View (SuCri4SelectFrontView)
  • 4.5.20. Selection (SuCri4SelectSupport)
  • 4.5.21. Setting the Scale of a View (SUCRI4SetOrthoScale)