IntegaDesign › SuCri® Knowledge Base › 📄 4.2 Drawing selection

4.2.37. Selection Double Support (SuCri2SelectDoubleSupport)

4.2.37. Select Double Support (SuCri2SelectDoubleSupport)

Copyright © 2025 by IntegaDesign GmbH. All Rights Reserved.
  • 4. Calculation of the screw length
  • 4.2.2. Selection (SuCri2SelectSupport)
  • 4.2.3. Replace [DWG] (SuCri2ReplaceExistingSupportDWG)
  • 4.2.4. Bracket (SuCri2AutoSelectSupport)
  • 4.2.5. Export supports (SuCri2ExportPrimarySupport)
  • 4.2.6. Bracket [x] (SuCri2AutoSelectMultipleSupport)
  • 4.2.7. Info (SuCri2SupportXdata)
  • 4.2.8. Clamping system [x] (SuCri2AutoSelectMultipleClamp)
  • 4.2.9. Clamping system (SuCri2AutoSelectClamp)
  • 4.2.10. Detach (SuCri2DetachSupport)
  • 4.2.11. Mount + clamping system (SuCri2AutoSelectSupportClamp)
  • 4.2.12. Align Faces (SuCri2AlignFace)
  • 4.2.13. Attach Double Support (SuCri2AttachDoubleSupport)
  • 4.2.14. Appending with Reference (SuCri2AttachSupportWithRef)
  • 4.2.15. Automatic Plates (SuCri2AutoAddPlate)
  • 4.2.16. Automatic Screws (SuCri2AutoAddScrewForPlate)
  • 4.2.17. Bracket + Clamping System [x] (SuCri2AutoSelectMultipleSupportClamp)
  • 4.2.18. Creating Dummy Parts (SuCri2CleanDummyParts)
  • 4.2.19. Detach all Xrefs (SuCri2DetachAllXref)
  • 4.2.20. Release Double Support (SuCri2DetachDoubleSupport)