11.1. Current version, Release notes for SuCri
On this page
- Module 3: Implementation of the function "SuCri3SetItemCodes" for Plant 3D for improved item code management.
- Module 2: Fixed an error where the command "PLANTHIDE" could cause Plant 3D to freeze.
- Module 2: Resolved a conflict with BIMTrack that caused system crashes.
- Module 2: Fixed an error when pressing the Enter key during the selection of supports or clamps.
- Module 2: Corrected the MTO height display for locked lines.
- Module 2: Invalid supports are now ignored when copying properties.
- Module 3: Fixed an error where cutting a Python profile occasionally extended it too far.
- Module 3: Corrected the cutting behavior for Hilti angle connections in Plant 3D.
- Module 4: Removal of the faulty "H+E" function for multiple profiles.
- Module 4: System crashes with an empty bill of materials (BOM) are now prevented.
- Module 4: Corrected the behavior of the center lines.
- Module 4: Fixed an error where repeatedly copying the front area produced differing results.
- Module 4: Corrected the missing header display in the user interface.
- Module 1: Added a round steel bill of materials (BOM) for load chains (Sikla system).
- Module 2: The automatic support selection now also supports steel plates.
- Module 2: MTO templates now support custom name fields to map different header names to property names.
- Module 2: The "VendorCopy" function has been generalized; it now works without an index and supports steel structures, pipe assets as well as supports.
- Module 2: The formatting of the material takeoff lists (MTO) has been unified across all output types.
- Module 3: Added a new option for screws: These can now be configured so that they are not inserted and not shown in the ortho view.
- Module 3: Updated the Hilti library to the latest version.
- Module 3: Introduced a setting to define the cutback for M3 connections (default value increased to 7 mm, individually adjustable).
- Module 4: The warning "Structure width/height not found" is now output subtly in the command line instead of in a pop-up window.
- Module 4: Provision of a ready-to-use template in the resources folder.
- Module 4: The rounding of the total weight now follows the decimal settings of the drawing.
- Module 4: It is now possible to create multiple section views within one SuNo.
- Module 4: Additional properties are now shown in the bill of materials (BOM).
- Installer: The silent installer now supports specific parameters for module selection (-INSTALLDIR, -CHECKM2, -CHECKM3, -CHECKM4).
- Installer: Activation of verbose logging for improved error diagnosis of installation problems.