5.1.18. RestrictParameterForVendor
On this page
Overview
The support parameters of the manufacturers entered here are restricted according to the parameter restriction table (RestrictTable). If a parameter is restricted, it can only be set to the permitted values in the model. If you enter a value that is not permitted, SuCri reports this and sets the first permitted value.
You edit the restriction table in the Settings window, Module 2 tab, Restrict table subtab.
The change takes effect immediately after Save; a restart of Plant 3D is not necessary.
Where can I find the setting?
Open the Settings window with the command SuCriSettings or in the SuCri ribbon using the Settings button. On the left, select the Module 2 tab, then the General subtab, Placement and overrule group. There the setting is called Restrict parameters for vendors. Apply changes with Save.
Values
The default value of the RestrictParameterForVendor setting is Sikla, Hilti.
Possible values: comma-separated list of manufacturer names as used in the SuCri manufacturer data. An empty field means: no restriction.
Example
Value example
Related function
Used when you change a parameter of a support in the model.
Copyright © 2026 by IntegaDesign GmbH. All Rights Reserved.