4.5.14. Annotate view with custom annotations (SuCri4PlantOrthoCustomAnnotate)

Overview

This guide describes the function Annotate view with custom annotations (SuCri4PlantOrthoCustomAnnotate) of SuCri, a plugin for AutoCAD Plant 3D and Advance Steel. The function annotates a view with custom annotations.

Where do I find the function?

Call it via the command SuCri4PlantOrthoCustomAnnotate or via the ribbon SuCri > Module 4.

Plant 3D™ command

How it works in detail

1. Call the function:

   Call the function via the ribbon SuCri > Module 4 or enter the command SuCri4PlantOrthoCustomAnnotate in the command line.

2. Select components or point:

   Select the affected components or the reference point in the drawing. Confirm the selection with Enter if necessary.

3. Execute action:

   SuCri executes the function for the selection.

4. Check result:

   Check the result in the drawing and adjust it if necessary.

Tips and best practices

• Check before executing: Make sure the correct components are selected.
• Undo: Use Ctrl+Z to undo an accidental action.
• Save: Back up your project before making extensive changes.

Troubleshooting

• "Component cannot be selected": Check whether the layer is locked and whether it is a valid SuCri component.
• "Command not found": Make sure the SuCri plugin is loaded in the plugin manager.

Related articles

• Selection, marks the components of an assembly.
• Attaching, combines components into an assembly.
• Detach, removes individual components from the assembly again.

Copyright © 2026 by IntegaDesign GmbH. All Rights Reserved.