5.2.3. Angle tolerance, Module 3 Settings
On this page
Overview
Defines the maximum permissible angular deviation in degrees with which Module 3 compares the angle between the selected profiles with the angles that a connection supports. The setting therefore determines which connections are offered.
Where can I find the setting?
Open the Settings window with the command SuCriSettings or in the SuCri ribbon using the Settings button. On the left, select the Module 3 tab, General section. There the setting is called Angle tolerance (degrees). Every change is saved immediately; there is no save button on this tab.
Values
The default value of the AngleTolerance setting is 0.01 degrees.
Possible values: decimal number in degrees.
Example
Value 1 degree
Related function
This setting belongs to creating connections with Module 3, see Module 3 (P3D) and Module 3 (ADVS).
Copyright © 2026 by IntegaDesign GmbH. All Rights Reserved.