8.4.1. Problem when connecting Sikla-Pressix CC41 profiles in Plant 3D (Module 3)
On this page
8.4.1. Problem when connecting Sikla-Pressix CC41 profiles in AutoCAD Plant 3D (Module 3)
In this article you will learn how to deal with connection problems for Sikla-Pressix CC41 profiles within SuCri Module 3 in AutoCAD Plant 3D. Since new connections are implemented on a manufacturer-dependent basis, a specific process is required for integration.
Prerequisites
- Installation of AutoCAD Plant 3D
- Active SuCri Module 3
- Use of Sikla-Pressix CC41 profiles in your project
Step-by-step guide
-
Identify the problem
Check whether, when selecting a connection (e.g. a clamp SB 41 to connect a Pressix CC41 MS41/41/2.0 with an HEB100) via the Selection Method, a preselection appears.
-
Detect the missing connection
If no preselection appears for the selected Pressix CC41 profiles, this is because this specific connection is currently not yet stored in the SuCri database.
Expected result: You find that, in contrast to SiFramo profiles, no automatic assignment takes place.
-
Initiate a request to the manufacturer
Since new connections are implemented specifically by IntegaDesign after official commissioning, contact the manufacturer directly (e.g. Sikla).
-
Commissioning the integration
The manufacturer can then commission IntegaDesign with the technical integration of the new connection solutions.
-
Wait for the update
After implementation by IntegaDesign, the new connections are available in a future update of SuCri Module 3.
Important notes
- Background: While SiFramo connections are already comprehensively integrated, extensions for Pressix CC41 profiles must be commissioned individually.
- Availability: Until official integration, only the standard connections already stored can be used in SuCri.
Troubleshooting
- Missing preselection: If no result appears with the Selection Method, first check whether you are using a profile that is already supported. If not, follow the process via the manufacturer described above.