In this section you will find all the information and step-by-step instructions you need for the proper installation and setup of your modules. This documentation helps you prepare the software environment optimally for your daily work. You can find out which Autodesk versions the individual modules support under 2.1. System requirements.
Contents of this section
2.2.1. Module 1
This guide describes the installation of Module 1 and the required configuration of the symbol libraries and XML mappings.
2.2.2. Module 2
In this guide you will learn how to set up Module 2 correctly on your system using the supplied installation program.
2.2.3. Module 3 (P3D)
In this guide you will learn how to correctly install Module 3 for AutoCAD Plant 3D using the dedicated installation program.
2.2.4. Module 3 (ADVS)
In this guide you will learn how to install Module 3 for Advance Steel and set up the Advance Steel databases with the supplied patcher.
2.2.5. Module 4
This article describes the installation of Module 4 and the necessary configuration steps for project templates and bills of materials.
2.2.6. Module 5
The installation guide for Module 5 (secondary steel from templates, AutoCAD Plant 3D 2025 or later) is currently being prepared.
2.2.7. Uninstalling modules correctly
Learn how to avoid leftovers and perform a clean uninstallation to prevent conflicts with future updates.
2.2.8. Installation for enterprise customers
This section explains the specially prepared process for the efficient and centrally controlled distribution of the modules in larger corporate networks.
Note
Close AutoCAD Plant 3D and Advance Steel completely before every installation. After the installation, set up your license as described in the article 2.3. First run.