4.5.10. Load settings (SuCri4LoadSetting)
On this page
Note: This command is not part of the standard SuCri. It is only available in individual customer- or project-specific extensions and therefore does not appear in every installation.
Overview
This guide describes the function Load settings (SuCri4LoadSetting) of SuCri, a plugin for AutoCAD Plant 3D and Advance Steel. The function loads a saved settings file into the current session.
Where do I find the function?
Called via the command SuCri4LoadSetting or via the ribbon SuCri > Module 4.
Plant 3D™ command
Property | Value |
| Command | SuCri4LoadSetting |
| Ribbon | SuCri > Module 4 > Load settings |
| Shortcut | not assigned |
How it works in detail
Call the function:
Call the function via the ribbon SuCri > Module 4 or enter the command
SuCri4LoadSettingin the command line.Open the dialog or file:
SuCri opens the associated view, dialog or file.
Use the result:
Read the displayed information or make the desired settings.
Tips and best practices
- Read-only: Opening the dialog or file does not change the design.
- In case of errors: The error log file helps to narrow down the causes of problems.
Troubleshooting
- "File does not exist": The error log file is only created once an error has occurred.
- "Dialog does not open": Make sure that the SuCri plugin is loaded.
Related articles
- Selection, marks the components of an assembly.
- Attaching, groups components into an assembly.
- Detach, removes individual components from the assembly again.
Copyright © 2026 by IntegaDesign GmbH. All Rights Reserved.