Optimize isometrics by updating the dynamic properties before isometric generation. Learn how to document important assembly information completely and precisely.

Problem description

In the generated isometrics, the information on the primary supports appears, but the information on the clamping systems used is missing.

As a result, the outputs appear incomplete and important data for assembly and documentation is missing.

Cause

The cause is that before isometric generation the function Dynamic properties was not run.

  • Without this update, the system does not know the assignment between primary support and clamping system.
  • Isometric generation therefore only pulls the standard information, but not the extended information for clamping systems.

Solution

  • Run dynamic properties before isometric generation

Make sure that the dynamic properties are updated in the entire model.

This writes the clamping system information into the parts.

  • Start isometric generation again

After the update, generate the isometrics again.

The information on the clamping systems now appears correctly in the drawings.

Recommendation

  • Best practice: Always run the Dynamic properties function before isometric generation.
  • Define as a project guideline that the update is part of the regular workflow before creating isometrics.
  • This ensures that all necessary information, both primary supports and clamping systems, is output on the isometrics.